News

Nantong Guoji machinery Equipment Co., LTD. Specializes in the production of profile bending machine, profile bending machine also known as rolling bending machine, profile bending machine. Our company produces under the arc adjustable three roller profile bending machine, is a special for all kinds of profile bending forming a general equipment, can roll profiles into circular, arc, spiral shape and other workpieces, in petroleum, chemical industry, water and electricity, shipbuilding machinery manufacturing and large steel structure building industries, has a wide range of applications. But operators should use the profile bending machine according to the safe operation rules:

1. Operators should understand the structure and performance of the profile bending machine, familiar with the operation method of the control system and the bending process of the workpiece, and strictly observe the safe operation matters.

2. Before starting the profile bending machine, please carefully check whether the motor, switch, circuit and ground are normal and firm. Check the control parts of the device and whether the button position is correct. Check whether the mold meets the machining requirements.

3. In case of irregular noise, impact, swing or oil leakage during operation, stop immediately for inspection and repair.

4. Operators must tie tightly the clothes and cuffs. Aprons or noodles are strictly prohibited; Long hair women should work with their hair up and wear a hat to prevent safety accidents from being twisted.

5. During the operation of the equipment, the operator's hands and other parts of the body should not be closer to the roller than 20cm recently. Non-operators are strictly prohibited to stay in front of the equipment.

6. The equipment must be used within the capacity of the equipment, and overload is not allowed.

7. The position of the roller is adjusted by the profile bending machine according to the diameter of the winding circle. Before the work, the workpiece is debugable with waste materials.

8. When the profile is bent, it must be compacted to prevent the profile from warping and injury during bending.

9. If the machine or die is found to be incorrect during operation, the calibration shall be stopped. Correction by hand is strictly prohibited during operation to prevent injury.

10. After the work is finished, the power should be cut off and the power box should be locked.

11. The hydraulic transmission system should be checked regularly, and the failed hydraulic components should be adjusted and replaced timely.

12. The oil tank shall maintain the specified oil level to minimize the pollution of hydraulic oil, check the deterioration of hydraulic oil at least half a year, and replace it in time if it exceeds the requirements.

13. All live parts of the electrical system should be properly grounded, electrical components should be checked regularly, dust removal, timely replacement of damaged and invalid components. Each solenoid valve, limiter should often check and adjust.